You should check both your incense cone and your holder to figure out the exact problem. If you've followed all the instructions above, but still do not see smoke flowing down your backflow incense holder, there could be a couple of reasons for this. We do not personally use this method as we find it rather cumbersome. Some people find success with sprinkling a little water on the ash before attempting to clean it up. Use a vacuum to directly suck the burnt incense cone up (or a dustpan and small broom, although we find that this can get messy). ![]() You can find more details of how to do this including a video in our f ollow up article on disposal incense ash and cleaning backflow incense burners Move a trash bag or move your garbage can close to the incense (don’t try to move the incense holder), pick up the small metal plate the incense cone is sitting on, and gently tip the whole burnt cone into the trash - we've found this to be the easiest and cleanest method, and this is what we prefer.There are a couple of other suggestions that we have, but whatever method you choose, please ensure that you wait for the burnt incense cone to cool down (3-5min) before attempting anything else: This can be tricky as if you try to pick up the burnt incense cone, the ash will fall everywhere and make quite a mess. We often get asked the best way to dispose of burnt incense cone ash. Then sit back and enjoy some backflow magic! Be sure that the hole at the bottom of the incense aligns with the hole on the seat of the incense holder, or the incense plume will be blocked. If you do not see a glowing ember, and there is no smoke coming out of the bottom, you have completely extinguished the incense by accident, and will need to repeat steps 1-3 above If you're unsure, leave the incense for a minute or so, then check again. If you see a small glowing ember, and smoke starts coming out of the bottom, then the incense has been correctly lit. Check the incense tip where the flame was.For some incense you may need to wait for a short while before blowing out the flame to ensure it properly lights up. Gently fan or blow out the flame or remnants of the flame.Ensure that the incense is immersed in the flame until it ignites with a small flame (note the flame may not say lit as it might on a stick incense) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |